Pro-Built Tools PB1200 Series Manual de instalación descargar pdf (Pagina 39)

GTO 4000XL Instruction Manual © 091610 29

ADDITIONAL Accessories

Photo Beams [R4222]

Primary “through beam” photo beam device. Provides “non-contact” entrapment

protection.

Pin Lock [FM345]

Use as a substitute for the clevis pin at the front mount of the PRO-SW4000XL to

prevent theft of the operator.

 • PinLock10-pack:tenPinLockskeyedalike[FM345KA].

Push Button Control [RB10]

Wire this unlit push button directly to your gate operator for simple open/close/stop

operation from up to 1000 ft. away. Use 16 gauge low-voltage wire.

Replacement Transformer [RB570]

Standard 18 volt, 2200 mA AC transformer included with the 4000XL to maintain

battery charge.

HARDWARE Accessories

HBP4XL Bracket Set [HBP4XL]

Post mount hardware kit will allow the 4000XL to operate longer, heavier, gates (up

to 20 ft. and 1000 lbs.). Dual gates will require two bracket sets.

Push To Open Brackets [R4388/R4KPTO]

Required when the 4000XL must push a gate open (arm extends to open), such as

away from a sloping driveway or where space prevents gate from opening into the

property (pull to open). Order two brackets for a dual swing gate installation.

 • For4000XL[R4388]

 • For4000XLwhenusingHB4000BracketSet[R4KPTO]

Column Mount Lock Receiver [433IH]

For use with the Automatic Gate Lock or Bulldog Pedestrian Gate Lock when

mounting on brick columns or applications with limited space.

1 2 ... 34 35 36 37 38 39 40

Sin comentarios

Pro-Built Tools PB1200 Series Manual de instalación Pagina 39