Pro-Built Tools PB1200 Series Manual de instalación descargar pdf (Pagina 26)

16 GTO 4000XL Instruction Manual © 091610

Step 4

With the gate in the desired closed

position PRESS & HOLD the “LEARN

MAST LIMIT” button on the control board

for 5 seconds.

Step 5

Press the transmitter button and

allow the gate to return to the fully

open position (arm fully retracted).

The gate closed position limit is now

programmed.

TESTING YOUR CLOSED LIMIT SETTING:

Press your entry transmitter and allow

your gate to close. If the CLOSED

position is not correct or needs to be

changed, you will need to CLEAR your

CLOSED LIMIT settings and follow Steps

1-4 again.

CLEARING THE PROGRAMMED CLOSED

LIMIT SETTING:

If you make a mistake and set the limit

at the wrong position: press your

transmitter to return the gate to the fully

opened position, then press and hold

the “LEARN MAST LIMIT” button for 5

seconds. This will clear the memory for

the closed limit position. Repeat Steps

1-4.

Adjust the Stall Force Setting

The Stall Force potentiometer on the

control board controls the obstruction

sensitivity (or the amount of force the

operator will apply to an obstruction for

two (2) seconds before it automatically

stops and reverses direction).

IMPORTANT: For safety reasons

the stall force setting will need

to be adjusted for your particular

application.

The Stall Force potentiometer on the

control board operates like a volume

controlonaradio.Useasmallatblade

screwdriver to adjust the potentiometer.

Adjust the stall force from the MIN

position until the gate operates

smoothly without obstructing from its

own weight or wind conditions.

NOTE: you may need to increase the

stall force in cold temperatures due to

increased resistance from gate hinges.

Learn Master Limit

Button

1 2 3 4

ON DIP

STATUS

LEARN RMT

LEARN

MAST LIMIT

LEARN

2ND LIMIT

S3

S4

S2

SOFT START OFF

WARNING OFF

OPEN PULL

SLV OPEN DLY.

MODE1 OFF

MODE2 OFF

ON

ON

PUSH

SIMULT.

ON

ON

120 MIN MAX

AUTO CLOSE TIME STALL FORCE

1 2 3 4

ON DIP

OFF

SOFT START OFF

WARNING OFF

OPEN PULL

2ND OPEN DLY.

MODE1 OFF

MODE2 OFF

ON

ON

PUSH

SIMULT.

ON

ON

120 MIN MAX

AUTO CLOSE TIME STALL FORCE

1 2 3 4

ON DIP

OFF

SOFT START OFF

WARNING OFF

OPEN PULL

2ND OPEN DLY.

MODE1 OFF

MODE2 OFF

ON

ON

PUSH

SIMULT.

ON

ON

120 MIN MAX

120 MIN MAX

120 MIN MAX

120 MIN MAX

120 MIN MAX

120 MIN MAX

120 MIN MAX

AUTO CLOSE TIME STALL FORCE

AUTO CLOSE TIME STALL FORCE

OFF

PUSH

SIMULT.

120 MIN MAX

120 MIN MAX

AUTO CLOSE TIME STALL FORCE

1 2 3 4

ON

OFF

ON

ON

PUSH

SIMULT.

ON

ON

120 MIN MAX

AUTO CLOSE TIME STALL FORCE

MIN MAX

STALL FORCE

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 39 40

Comentarios a estos manuales

Sin comentarios